Download Print this page

Advertisement

Quick Links

01865 767676
sales@unicol.com
www.unicol.com
NST1 / NST2
Screen Size: 33-90"
Guide Max. Weight: 80-150kg
Revised 15/12/20
*Please check model specific details before installing*
WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your
carrier claims agent and do not continue the installation until it has been reviewed. Please watch for
pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any
spring loaded parts. Before installing, make sure that the supporting surface will support five times the
combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also
layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or
personal injury. This product is intended for indoor use only. We recommend using a qualified trades
person for installation. Use an assistant or lifting equipment to lift and position products.
For support, please call: +44 (0)1865 767676 or email: sales@unicol.com

Advertisement

loading

Summary of Contents for Unicol NST1

  • Page 1 This product is intended for indoor use only. We recommend using a qualified trades person for installation. Use an assistant or lifting equipment to lift and position products. For support, please call: +44 (0)1865 767676 or email: sales@unicol.com...
  • Page 2 01865 767676 sales@unicol.com www.unicol.com TOOLS REQUIRED INSTALLERS REQUIRED Pozi Head Screwdriver 5mm Allen Key 4mm Allen Key 19mm Spanner 17mm Spanner COMPONENTS DESCRIPTION Standard Rhobus Base Universal Mount Back Plate Universal Mount Arms Rhobus Mast (inc. cabinet door) Manoeuvrability Handle...
  • Page 3 01865 767676 sales@unicol.com www.unicol.com STEP 1 STEP 2 Laying the mast on a flat surface, offer the base Unlock and lift out rear door. Remove upper rear up and attach as shown above. All castors should panel by unscrewing 4x M6 screws.
  • Page 4 01865 767676 sales@unicol.com www.unicol.com STEP 6 STEP 5 Feed cables for screen through hole in backplate Locate the mounting holes on the back of your and front of mast and down through cable access. screen. Line the two mounting arms up and using Refit rear top panel using x4 M6 screws.

This manual is also suitable for:

Nst2