Table of Contents
Advertisement
ENGLISH
Playback using the external input (EXT. IN) jacks
1
Set the external input (EXT.
IN) mode.
Press the EXT. IN to switch
the external input.
Once this is selected, the input signals connected to the FL
(front left), FR (front right) and C (center) channels of the EXT.
IN jacks are output directly to the front (left and right) and
center speaker systems as well as the pre-out jacks without
passing through the surround circuitry.
In addition, the signal input to the SW (subwoofer) jack is
output to the PRE OUT SUBWOOFER jack.
2
Cancelling the external input mode
To cancel the external input (EXT. IN) setting, press the INPUT
MODE (AUTO, PCM, DTS) or ANALOG button to switch to
the desired input mode. (See page 36.)
INPUT MODE
• When the input mode is set to the external input (EXT. IN), the play
mode (DIRECT, STEREO, DOLBY/DTS SURROUND, 5CH/6CH
STEREO or DSP SIMULATION) cannot be set.
After starting playback
[1] Adjusting the sound quality (tone)
The tone control function will not work in the direct mode.
1
The tone switches as follows each time the TONE CONTROL
button is pressed.
TONE
CONTROL
(Main unit)
2
With the name of the volume to be
adjusted selected, turn the SELECT
knob to adjust the level.
• To increase the bass or treble: Turn the control clockwise.
(The bass or treble sound can be increased to up to +12 dB
in steps of 2 dB.)
• To decrease the bass or treble: Turn the control clockwise.
(The bass or treble sound can be decreased to up to –12 dB
in steps of 2 dB.)
38
EXT.IN
(Main unit)
(Remote control unit)
ANALOG
INPUT MODE
(Main unit)
(Remote control unit)
BASS
1
(Main unit)
EXT.IN
B
ANALOG
NOTES:
• In play modes other than the external input mode, the signals
connected to these jacks cannot be played. In addition, signals
cannot be output from channels not connected to the input
jacks.
• The external input mode can be set for any input source. To
watch video while listening to sound, select the input source to
which the video signal is connected, then set this mode.
B
TREBLE
SELECT
3
If you do not want the bass and treble to be adjusted, turn on
the tone defeat mode.
REMOTE
SIGNAL
SENSOR
LOCK
DIGITAL
INPUT
STAND BY
AUTO
DIGITAL
PCM
2 1
VOLUME
DISC SKIP+
DOLBY / DTS
SPEAKER
SURROUND
DIRECT
DSP SIMULATION 5CH / 6CH STEREO
STEREO
MASTER VOL.
INPUT MODE
ANALOG
EXT.IN
2
TAPE
CDR/MD
AUDIO
CD
MULTI
MUTING
AVR/AVC
VIDEO
DVD
TV
VDP VCR
SYSTEM
SURROUND
TUNING
SETUP
PARAMETER
TITLE
MENU/GUIDE
BAND
CH SELECT
ENTER
MODE
SELECT
REMOTE
SIGNAL
SENSOR
LOCK
DIGITAL
INPUT
STAND BY
AUTO
DIGITAL
PCM
3
TONE DEFEAT
The signals do not pass through the
bass and treble adjustment circuits,
providing higher quality sound.
VOLUME LEVEL
1
VOLUME LEVEL
2
1
Advertisement
Table of Contents
