Installation Procedures; General Procedure; Figure 7-37. Atf Ports; Figure 7-38. Atf Bulkhead - CAIRE SAROS 4000 Service Manual

Service Manual
7.7.8.5 Cap both ATF ports (Feed and Vacuum ports).
Cap 2X

Figure 7-37. ATF ports

7.7.8.6 Remove the ATF Bulkhead FROM the bottom of the ATF
Module Assembly as shown in figure below.
ATF module assy
(SP9729-SEQ)
NOTE: Mark the position for installation.
ATF bulkhead assy
(9922-SEQ)

Figure 7-38. ATF bulkhead

7.8 INSTALLATION PROCEDURES

7.8.1 GENERAL PROCEDURE

7.8.1.1 Thread Locking Procedure: When applying thread locker
to screws, apply 1 drop of the appropriate thread locking fluid to
Thread Locker
the first four threads of the screw/standoffs as show in the figure
below. The Loctite 222MS will be used unless specified other-
wise.

Figure 7-39. Thread Locking Procedure

7.8.1.2 CABLE TIE INSTALLATION PROCEDURE: All cable
ties will be installed using cable tie gun unless specified other-
wise.

Figure 7-40. Cable tie installation

MN260 B | 37