Temperature Controls; Allowing Cooling Time Before Use; Setting Cooling Temperatures/Adjustment - Frigidaire FSC23F7HS Use And Care Manual

ALLOWING COOLING TIME BEFORE USE

To ensure safe food storage, allow your refrigerator to operate with
the doors closed for at least 8 to 12 hours before placing food inside.
During this cooling period, you do not need to adjust the controls,
which are preset at the factory.
SETTING COOLING TEMPERATURES
Your refrigerator comes with a state-of-the-art electronic digital
control system. The system's control panel is located at the top of the
the fresh food compartment.
The two digital displays on the left half of the control panel indicate
the current settings or temperatures of your freezer and fresh food
compartments. The models with a 2-digit temperature display are for
reference only, and do not display the current accurate compartment
temperature. Should you desire to see what the current accurate
temperature is, place a separate thermometer inside the freezer or
fresh food compartment in the desired location.
TEMPERATURE ADJUSTMENT
After 24 hours, adjust the controls as needed. Make your
adjustments small and gradual; allowing time for temperatures
to change and stabilize. Refer to the adjacent guidelines for
temperature settings.
To adjust the temperature to a higher or lower setting, press the
Up or Down button closest to the display. The first time you
press the button, the display shows the last setting you entered.
Each press of the button after that increments the setting by
one degree.
The display shows your new setting momentarily, then changes
back to the current temperature.
Temperature Adjustment Guide
If Fresh Food compartment is too warm
If Fresh Food compartment is too cold
If Freezer compartment is too warm
If Freezer compartment is too cold
Air Filter Status Light (not available on all models)
Green
Yellow
Red

TEMPERATURE CONTROLS

Adjust Fresh Food control one degree
colder by pressing Down (Colder) button.
Adjust Fresh Food control one degree
warmer by pressing the Up (Cold) button.
Adjust Freezer control one degree colder
by pressing Down (Colder) button.
Adjust Freezer control one degree warmer
by pressing the Up (Cold) button.
Filter OK.
Air filter is about 80 percent used. Please order new one.
Air filter is 100 percent used. Please change now.
NO NOTE NO
NO NO
The advanced electronic control
system in your refrigerator includes
additional display modes that
service professionals can use to
rapidly diagnose performance
issues.
IF TEMPERATURE DISPLAYS FLASH...
If ever you see both temperature displays continously flashing,
it may indicate that the control system has detected a
performance problem. Call your service representative, who
can interpret the flashing message.
To maintain temperatures, a fan circulates air in the refrigerator
and freezer compartments. For good circulation, do not block
cold air vents with food items.
Temperature Display (2-Digit)
Warmest
Factory Setting
Coldest
AIR FILTER INDICATOR & STATUS LIGHTS
Your refrigerator's air filter needs to be replaced from time to
time. You can monitor the need for replacement by referring to
the status light while the air filter is "ON". To turn on the air filter,
press the "Air Filter" button. To turn off the air filter, press the
"Air Filter" button. To RESET the air filter, press the "Air Filter"
button and hold for 3 seconds.
CA CAUTION - SOME MODELS CA UTION - SOME MODELS UTION - SOME MODELS UTION - SOME MODELS
CA CA UTION - SOME MODELS
The alarm system does not automatically reset if you
disconnect and reconnect your refrigerator's power cord.
It can only be reactivated by pressing the Alarm Reset
button.
6
TE TE TE
TE
Freezer Fresh Food
F° C° F° C°
6° -14° 47° 8°
0° -18° 37° 3°
-6° -21° 33° 1°