Hague WaterMax H3500 Owner's Manual And Installation Manual page 22

Installation Steps and Start-Up Procedures, Cont.
Install the Drain Saddle Assembly
Step 6
The drain assembly should be installed above the P-trap on the vertical or horizontal tailpiece.
(See Figure 9)
A.
Position the drain saddle in the desired
location, mark the spot to be drilled, and
remove the saddle. (See Figure 10)
B. Drill a 7/16-inch hole through one side of drain
pipe only.
C. Peel off the white backing from the drain gasket
and apply the gasket to the "port" connection of
the drain saddle.
Make sure to align the drain saddle to the
drilled hole. Attach the drain saddle to the drain
pipe and tighten the two screws evenly.
D.
Cut the 3/8-inch black tube to desired length
and connect to the drain saddle with the
provided clip.
Note: State and local plumbing codes may prohibit
the use of saddle valve connections.
A
WaterMax RO Owner's Manual
B
C
Figure 10: Drain Saddle Assembly
Figure 9: Drain Saddle Assembly
Mounting Locations
9/2020 22