Hague WaterMax H3500 Owner's Manual And Installation Manual page 18

Installation Steps and Start-Up Procedures Con't
A. Cut tube square
Cut the tube square. It is essential that the outside
diameter be free of score marks and that burrs and sharp
edges be removed before inserting into fitting.
B. Insert tube
The fitting grips before it seals.
C. Push up to tube stop
Push the tube into the fitting to the tube stop. The collet
(gripper) has stainless-steel teeth that hold the tube firmly
in position while the O-Ring provides a permanent
leak-proof seal.
WaterMax RO Owner's Manual
D. Insert the locking clip
Collet
Insert the locking clip. The locking clip secures the collet in its
position to prevent an accidental disconnection of the tube.
E. Pull to check security
Pull on the tube to check that it is secure. Test the appliance
before leaving the site or before use.
F. Disconnecting
To disconnect, ensure that the appliance is depressurized.
Remove the locking clip. Push in the collet squarely against
face of the fitting. With the collet held in this position, the tube
can be removed. The fitting can then be re-used.
9/2020 18