Construction camera with long-range wireless bridge (2 pages)
Summary of Contents for iBeam TE-3BDP
Page 1
TE-3BDP User Manual iBeamUSA.com MetraDealer.com techsupport@metra-autosound.com � TECH SUPPORT 800-253-8324...
Page 2
1. Brake light camera 2. Accessories 1. 10m extension cable 2. 4-pin to RCA adapter 3. DC power cable 4. Two male to male adapters 5. Brake power cable 6. Gasket (not shown)
Page 3
3. Connections 1. Remove factory 3 brake light. 2. Connect red wire off new brake light to +12v and black to ground at factory brake light connector. This connection will power the brake light when the brake is pressed. Run extension cable though vehicle, up to monitor. Make sure to run cable in the correct orientation (female end to monitor and male end to camera).
Page 8
IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated.
Need help?
Do you have a question about the TE-3BDP and is the answer not in the manual?
Questions and answers