Canon EOS 350D Instruction Manual page 81

Differences Between <d> and <1> (Full Auto)
¡
In both modes, the automatically-set shutter speed and aperture
combination are the same.
In the < d > mode, you can set or use the functions below, but not in the < 1 > mode.
¡
Shooting Settings
¡
AF mode selection
¡
AF point selection
¡
Drive mode selection
¡
Metering mode selection
¡
Program Shift
¡
Exposure compensation
¡
AEB
¡
AE lock with <A> button
¡
Depth-of-field preview
¡
Clear all camera settings
¡
Custom Function (C.Fn)
¡
Clear all Custom Functions
¡
Sensor cleaning
Flash Settings (Built-in flash)
¡
Flash On/Off
¡
FE lock
¡
Flash exposure compensation
About Program Shift
¡
In Program AE mode, you can freely change the shutter speed and
aperture value combination (program) set by the camera while
maintaining the same exposure value. This is called program shift.
¡
To do this, press the shutter button down halfway, then turn the <6>
dial until the desired shutter speed or aperture value is displayed.
¡
Program shift is canceled automatically after the image is captured.
¡
If you use flash, you cannot use program shift.
¡
If "30"" and the maximum aperture blink, it indicates
that the subject is too dark. Increase the ISO speed
or use flash.
¡
If "4000" and the minimum aperture blink, it indicates that the
subject is too bright. Decrease the ISO speed or use an ND
filter (optional) to reduce the amount of light entering the lens.
Flash Settings (EX-series Speedlite)
¡
Manual/stroboscopic flash
¡
High-speed sync (FP flash)
¡
FE lock
¡
Flash ratio control
¡
Flash exposure compensation
¡
FEB
¡
2nd-curtain sync
¡
Modeling flash
Image-Recording Settings
¡
RAW, RAW+7L selection
¡
ISO speed setting
¡
White balance selection
¡
Custom white balance selection
¡
White balance correction
¡
WB bracketing
¡
Color space selection
¡
Processing parameter setting
d Program AE
81