Table of Contents
Advertisement
To activate the optional accessory, press the option button on the key-
chain transmitter. The optional accessory will immediately engage.
NOTE: If your system utilizes the transmitter shown, the second option
button may be configured to operate additional accessories.
Please consult your installing retailer for more information concerning
the options available.
PUSH-BUTTON LED RECEIVER
VALET/OVERRIDE/SAFETY CONTROLSWITCH
The Push-Button LED switch located in the receiver allows you to
temporarily disable the remote starting function of the system. This is
recommended whenever the vehicle is being serviced.
To place the system in the service mode:
1) With the system disarmed/unlocked, and the ignition switch off, Press
and Hold the Push-Button, found on the windsheild receiver, in.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED begins to flash two short flashes followed by one long
flashes and continues this pattern until returned to normal mode of
operation.
This means the unit into the R/S Override mode indicating that the re-
mote start is in the service mode and will not start from RF or any other
input Car Connection, Car Link or otherwise.
To exit the service mode:
1) With the system disarmed, Press and Hold the Push-Button, found on
the windsheild receiver, in.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED turns off indicating that the R/S unit is fully functional one
again.
This system provides a means to cool down the vehicles turbo charger,
if so equipped, by allowing the vehicle to continue to run for a prescribed
period of time every time the vehicle's engine is turned off. This feature
requires the system to be set up for turbo timer during installation. Con-
sult with your installation center to be certain this feature was activated
TURBO TIMER MODE
Page 6
128-9446
6 of 12
Advertisement
Table of Contents
