Table of Contents
Advertisement
3.1
General
The CPE mounting kit, which enables several mounting options such as in the following
examples:
1. Poles
2. Walls
When choosing the mounting location for the unit, consider the available mounting
structures, antenna clearance.
3.2
Site Survey
Most wireless networks include many CPEs and BSTs installed in various locations in an
overlapping radio-cell pattern. It is important to position each CPE at an optimal location and
the assignment of its radio channels. Therefore, a site survey becomes an essential first step
before physically deploying the RuggedCom solution.
Installation of the CPEs requires a backhaul to interface the corporate network or Internet.
This backhaul connection can be an Ethernet-wired connection, a wireless–connection, or a
third party solution.
The site survey should include a detailed planning of the WiMAX system deployment. The
system deployment plan should include mounting points and the routes for the power and
backhaul cables.
Recommended Site Requirements
It is highly recommended that the WiN5200 CPEs be mounted near the edge of the roof of a
tall building. The WiN5200 CPEs should be pointed in the direction of the area to be covered.
To provide maximum coverage, multiple WiN5200 CPEs can be installed on the same
rooftop. However, it is important to leave some distance between each unit in order to
prevent interference between the units themselves. When choosing the ideal location, it is also
important to take into consideration the overall area topology.
WiN5200
Mounting | 28
Advertisement
Table of Contents
Need help?
Do you have a question about the WiN52 Series and is the answer not in the manual?
Questions and answers