Table of Contents
Advertisement
2 - 12
Wiring the framegrabber
•
Run the end of the power cable with the free cable ends from the framegrabber to the
lateral duct (13/Fig. 15) up to the ON/OFF assembly.
•
Connect the two ends (bn and bl) of the power cable to terminal blocks X2.1 and X2.2.
•
Connect the protective conductor (ye/gn) of the power cable to the protective conductor
terminal.
•
Insert the connector from the power cable in the power socket of the framegrabber
(5/Fig. 15).
•
Run the end of the remote cable (7/Fig. 15) from the framegrabber to the MEMOSKOP.
•
Connect the 9-pin SUB-D connector to the MEMOSKOP "Printer" socket and secure
with screws.
•
Connect the adapter cable for the remote control (3.5mm jack - BNC connector) to the
"B&W" BNC socket and lock (6/Fig. 15).
•
Connect the 3.5 mm jack at the other end of the adapter cable to the 3.5 mm remote
connector (7/Fig. 15). Remove first the heat shrink.
•
One end of the printer control cable is already connected to the printer. The printer
control cable is fed to the framegrabber via the power chain and has a 25-pin SUB-D
connector at the second cable end.
Connect the 25-pin SUB-D connector to the "Printer" socket of the framegrabber
(10/Fig. 15).
Wiring of the framegrabber video cable
NOTICE
•
Connect one end of the video cable to the 15-pin SUB-D socket "Video In" of the
framegrabber (8/Fig. 15).
•
With no additional video components present, e.g. a video recorder:
Run the other end of the video cable through the right duct (14/Fig. 15) to the
MEMOSKOP. Plug the BNC connector to the "OUT3" socket of the MEMOSKOP and
lock.
•
With video recorder or vidoe printer present:
Run the other end of the video cable to the video recorder or video printer.
•
Connect the BNC connector to the looped-through output of the video recorder or
vidoeprinter and lock.
•
The 75-ohm terminator on the video recorder or video printer must be disconnected or
unplugged.
SIREMOBIL Compact
System Manual
The framegrabber is equipped with a 75-ohm terminating resistor
which cannot be disconnected. If additional video components,
e.g. a video printer or video recorder, are present, the framegrab-
ber must always be wired as the last video component.
SPR2-130.814.01
Rev. 01
Page 12 of 14
03.01
TD PS 24
Installation
2
2
Siemens AG
Medical Solutions
Advertisement
Table of Contents
