Broan B5836SS Manual page 5

6" ROUND
DUCT ELBOW
10. Measure and install 6" round steel ductwork to roof cap or
wall cap and 90 elbow over duct collar on hood. Use duct
o
tape to make all joints secure and air tight.
11. Plug hood power cord into the outlet.
LOWER FLUE MOUNTING BRACKET
LOWER
FLUE
NOTE: 10-ft. ceilings require 10-ft. Flue Extension Model
FXN58SS (purchase separately). Discard the upper flue
supplied with your hood and replace it with the Model
FXN58SS flue extension.
12. Remove the upper flue from inside the lower flue. Install the
lower flue bracket to the lower flue using (2) flue bracket
screws #8 x 3/8", make sure that the slots are at the top.
Carefully replace the upper flue inside the lower flue.
Remove protective plastic film covering the lower flue only.
13. Carefully place both flues into the recessed area of hood
top. Slightly push aside the upper flue to avoid any damage
while installing the lower flue to the hood top using (2) #8 x
3/8" screws through the lower flue side slots.
MODELS B5830SS • B5836SS
UPPER FLUE MOUNTING BRACKET
UPPER
FLUE
14. Slide the upper flue upward until it is aligned with its upper
mounting bracket. The bracket should be inside the flue.
Secure the upper flue to the upper flue mounting bracket
using (2) #8 x 3/8" mounting screws.
15. Remove protective plastic film covering the upper flue and
the hood.
INSTALL THE HOOD
(Vertically Ducted Hoods Only)
1. DO NOT REMOVE the protective plastic film covering the
decorative flue and the hood at this time.
2. Lay the back side of the hood flat on a table. Use a piece of
cardboard to avoid damaging the table or the hood.
3. Attach damper / duct connector to top of hood using (4) #8
x 3/8" Pan Head mounting screws.
4. Remove the grease filters by pulling down the metal latch
tab and tilting filters downward to remove.
5. Carefully rotate hood upright.
LOWER FLUE MOUNTING BRACKET
LOWER
FLUE
NOTE: 10-ft. ceilings require 10-ft. Flue Extension Model
FXN58SS (purchase separately). Discard the upper flue
supplied with your hood and replace it with the Model
FXN58SS flue extension.
6. Remove the upper flue from inside the lower flue. Install the
lower flue bracket to the lower flue using (2) flue bracket
screws #8 x 3/8", make sure that the slots are at the top.
Carefully replace the upper flue inside the lower flue.
Remove protective plastic film covering the lower flue only.
7. Carefully place both flues into the recessed area of hood
top.
Page 5