Table of Contents
Advertisement
If the product has an emergency water draining hose, in order to drain the water:
If the product does not have an emergency water drain hose, in order to drain the water:
4
Clean any residues inside the filter as well as fibers, if any, around the pump impeller region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If it is one piece, seat
the tabs in the lower part into their places first, and then press the upper part to close.
54 / EN
a
Pull the emergency draining hose out from its seat
b
Place a large container at the end of the hose. Drain
the water into the container by pulling out the plug at
the end of the hose. When the container is full, block
the inlet of the hose by replacing the plug. After the
container is emptied, repeat the above procedure to
drain the water in the machine completely.
c
When draining of water is finished, close the end by
the plug again and fix the hose in its place.
d
Turn and remove the pump filter.
a.
In order to collect the water to flow out of the filter,
place a large vessel in front of the filter.
b.
Turn and loosen the pump filter until water starts to
flow (counterclockwise). Fill the flowing water into
the container you have placed in front of the filter.
Always keep a piece of cloth handy to absorb any
spilled water.
c
When the water inside the machine is finished, take
out the filter completely by turning it.
Washing Machine / User's Manual
Advertisement
Table of Contents
