Table of Contents
Advertisement
Changing handles position
N: Factory set position.
N: Alternate position.
CCUUIION: Four or more handles are required when
transporting.
Ensure the handles are attached by the
removed screws. (Recommended Fasten
Force: 139 - 189 N•cm)
V654Q/V754Q
V864Q
V984Q
Changing OEC logo ornament position
When using the monitor in the portrait position, the NEC logo
ornament position can be changed.
Removing the logo ornament: unscrew the installed screw
then take off the logo ornament.
Attaching the logo ornament: make sure the holes for the
screws on the logo ornament and the holes for the screws
on the bezel are aligned. Install the logo ornament with the
screws, which are used for installing the logo ornament.
(Recommended Fasten Force: 30-40N•cm).
Screw holes
CCUUIION: Do not use any other screw to install the logo
ornament.
Cttaching Mounting Cccessories
The monitor is designed for use with the VESA mounting
system.
1. Cttach eyebolts (not included) for
mounting
This model is equipped with attachable eyebolts to aid in
mounting.
•
Install the eyebolt brackets with the attached screws.
(Recommended Fasten Force: 139 - 189 N•cm)
•
Screw the eyebolts into eyebolt holes in eyebolt brackets
as shown in the picture.
•
Be sure eyebolts are secure.
•
In order to move the monitor into position, use a lifting
device attached to the eyebolts.
CCUUIION: DI OIU mount the monitor using only the
eyebolts. Eyebolts are for tentative use only.
2. Cttach Mounting Cccessories
Be careful to avoid tipping the monitor when attaching
accessories.
VESA Mounting Interface (M8)
Mounting accessories can be attached with the monitor in
the face down position. To avoid scratching the LCD panel,
always place a soft cloth, such as a blanket that is larger
than the monitor's screen area, on the table before laying the
monitor face down. Make sure there is nothing on the table
that can damage the monitor.
OIUEN:
Prior to installation, place the monitor face down
on a flat even surface that is larger than the
monitor screen.
Use a sturdy table that can easily support the
weight of the monitor.
OIUEN:
You can use 600 mm/400 mm holes for mounting.
English-7
400 mm
Advertisement
Table of Contents
