Table of Contents
Advertisement
Care and Cleaning
Damp objects stick to cold
metal surfaces. Do not touch refrigerated
surfaces with wet or damp hands.
To avoid damage and
help refrigerator run as efficiently as
possible, clean the condenser and air
vent s pe ri od i ca ll y .
Air Vents on Lower Access Panel
Keep your refrigerator and freezer clean to prevent odor build-up. Wipe any spills
immediately, and clean both sections at least twice a year. Never use metallic
scouring pads, brushes, abrasive cleaners, or strong alkaline solutions on any
surface. Do not wash any removable parts in a dishwasher.
Always unplug the power cord from the wall outlet before cleaning. NOTE:
Turning the control to OFF does not disconnect power to the controls, light bulb,
or other electrical components.
Inside
Wash inside refrigerator and freezer surfaces with a solution of 2 tablespoons
baking soda in 1 quart warm water. Rinse and dry thoroughly. Be sure to wring
excess water out of sponge or cloth before cleaning around the controls, light
bulb, or any electrical parts.
Wash removable parts such as shelves and drawers with baking soda solution,
or mild detergent and warm water. DO NOT USE HARSH CLEANERS ON THESE
SURFACES. Rinse and dry thoroughly. Clean the door gaskets with mild suds, rinse
with clear water and wipe dry. Do not use razor blades or other sharp instruments
that can scratch the appliance surface when removing adhesive labels. Any glue
left from the tape or energy label can be removed with a mixture of warm water
and mild detergent, or, touch the residue with the sticky side of tape already
removed. DO NOT REMOVE THE SERIAL PLATE.
Outside
Wash the cabinet and handles with warm water and mild liquid detergent. Rinse
well, and wipe dry with a clean soft cloth. Do not use commercial household
cleaners, ammonia, or alcohol to clean handles.
Toe Grill:
Remove any dust or dirt from the front of toe grill using a vacuum cleaner with
its dusting tool attachment. Remove toe grill by pulling it straight out. While grill
is removed, vacuum the back of grill, and wipe with a sudsy cloth or sponge.
Periodically clean the condenser (black tubes and wires beneath refrigerator,
behind toe grill). Do not allow lint or dust to accumulate on the coils. Insert a long
handled brush or vacuum attachment between the two coils to bring the lint
forward. To replace toe grill, line up tabs with holes, and push grill straight on.
there may be sharp.
Lower Access Panel:
As shown below left, air vents on the lower access panel at the rear of the
refrigerator should be cleaned periodically. Clean vents by using a vacuum
cleaner with its dusting tool attachment. When moving the refrigerator, pull
straight out. Do not shift refrigerator from side to side. This may tear or gouge
the floor covering. Be careful not to move refrigerator beyond plumbing
connections.
Vents
Use caution when cleaning in the area of the coils. Surfaces
Advertisement
Table of Contents
