Ordering Spare Parts - Stihl MSE 250 C Instruction Manual

English
Power consumption:
Fuse:
Type of enclosure:
Insulation:
27.2 Chain lubrication
Fully automatic speed-controlled oil pump with
reciprocating piston
Oil tank capacity:
27.3 Weight
with bar and chain, without cord
MSE 250 C
27.4 Cutting Attachment
(MSE 250 C)
Actual cutting length may be less than the speci‐
fied length
27.4.1 Rollomatic E guide bars
Cutting lengths:
Pitch:
Groove width:
Nose sprocket:
27.4.2 3/8" Chains
Rapid Super 3 (36 RS3) Type 3626
Pitch:
Drive link gauge:
27.4.3 Chain sprocket
8-tooth for 3/8"
27.5 Noise and Vibration Data
Noise data is determined on the basis of the
rated maximum speed.
Vibration data is determined on the basis of the
full load operating mode.
For further details on compliance with Vibration
Directive 2002/44/EC see www.stihl.com/vib.
27.5.1 Sound pressure level L
EN 60745‑2‑13
MSE 250 C:
27.5.2 Sound power level L
EN 60745‑2‑13
MSE 250 C:
27.5.3 Vibration measurement a
EN 60745‑2‑13
MSE 250 C:
30
2.5 kW
16 A
IP 20
II, E
200 cc (0.2 l)
5.8 kg
37, 40, 45 cm
3/8" (9.32 mm)
1.6 mm
10-tooth, 11-tooth
3/8" (9.32 mm)
1.6 mm
to
p
94 dB(A)
to
w
105 dB(A)
to
hv
Handle, left Handle,
right
2
3.1 m/s 4.1 m/s
The K‑factor in accordance with Directive
2006/42/EC is 2.0 dB(A) for the sound pressure
level and sound power level; the K‑factor in
accordance with Directive 2006/42/EC is
2
2.0 m/s for the vibration level.
The vibration values quoted above have been
measured according to a standardized test pro‐
cedure and may be used to compare electric
power tools.
Depending on the type of usage, the vibrations
that actually occur may differ from the values
quoted.
The vibration values quoted may be used for an
initial assessment of the user's exposure to
vibrations.
The actual exposure to vibrations has to be eval‐
uated. This process may also take into account
times during which the electric power tool is
switched off and times during which it is switched
on but running without load.
Observe measures to reduce vibration exposure
to protect the user – see section on "Vibrations"
in chapter on "Safety Precautions and Working
Techniques".
27.6 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation (EC) No. 1907/2006 see
www.stihl.com/reach.

28 Ordering Spare Parts

Please enter your saw model, serial number as
well as the part numbers of the guide bar and
saw chain in the spaces provided. This will make
re-ordering simpler.
The guide bar and saw chain are subject to nor‐
mal wear and tear. When purchasing these
parts, always quote the saw model, the part
numbers and names of the parts.
Model
Serial number
Guide bar part number
2 Chain part number
28 Ordering Spare Parts
0458-764-0121-B