Ordering Spare Parts; Maintenance And Repairs - Stihl MS 382 Instruction Manual

English
28.4 Chain Lubrication
Fully automatic, speed-controlled reciprocating
oil pump. Additional manual oil flow control
Oil tank capacity:
28.5 Weight
dry, without bar and chain
MS 382:
28.6 Cutting Attachment
Actual cutting length may be less than the speci‐
fied length
28.6.1 Rollomatic E guide bars
Cutting lengths:
Pitch:
Groove width:
Nose sprocket:
28.6.2 Rollomatic ES guide bars
Cutting lengths:
Pitch:
Groove width:
Nose sprocket:
28.6.3 3/8" chains
Rapid Micro (36 RM) Type 3652
Rapid Super (36 RS) Type 3621
Rapid Super 3 (36 RS3) Type 3626
Pitch:
Drive link gauge:
28.6.4 Chain sprocket
7-tooth for 3/8" (rim sprocket)
Max. chain velocity to ISO 11681:
Chain speed at maximum power
output:
28.7 Noise and Vibration Data
For further details on compliance with Vibration
Directive 2002/44/EC see www.stihl.com/vib.
28.7.1 Sound pressure level L
106 dB(A)
28.7.2 Sound power level L
118 dB(A)
28.7.3 Vibration measurement a
ISO 22867
Left handle:
Right handle:
28.8 Exhaust Emissions
The CO value measured in the EU type appro‐
2
val procedure is specified at
38
360 cc (0.36 l)
6.2 kg
40, 45, 50, 63 cm
3/8"
1.6 mm
11-tooth
40, 45, 50, 63 cm
3/8"
1.6 mm
11-tooth
3/8" (9.32 mm)
1.6 mm
27.5 m/s
21.7 m/s
to ISO 22868
p
to ISO 22868
w
to
hv,eq
5.9 m/s
5.7 m/s
www.stihl.com/co2
in the product-specific technical data.
The measured CO
representative engine in accordance with a
standardized test procedure under laboratory
conditions and does not represent either an
explicit or implied guarantee of the performance
of a specific engine.
The applicable exhaust emission requirements
are fulfilled by the intended usage and mainte‐
nance described in this User Manual. The oper‐
ating license shall be void if the engine is modi‐
fied in any way.

29 Ordering Spare Parts

Please enter your saw model, serial number as
well as the part numbers of the guide bar and
saw chain in the spaces provided. This will make
re-ordering simpler.
The guide bar and saw chain are subject to nor‐
mal wear and tear. When purchasing these
parts, always quote the saw model, the part
numbers and names of the parts.
Model
Serial number
Guide bar part number
Chain part number

30 Maintenance and Repairs

Users of this machine may only carry out the
maintenance and service work described in this
user manual. All other repairs must be carried
out by a servicing dealer.
STIHL recommends that you have servicing and
repair work carried out exclusively by an author‐
ized STIHL servicing dealer. STIHL dealers are
regularly given the opportunity to attend training
courses and are supplied with the necessary
technical information.
When repairing the machine, only use replace‐
2 ment parts which have been approved by STIHL
2
for this power tool or are technically identical.
Only use high-quality replacement parts in order
to avoid the risk of accidents and damage to the
machine.
29 Ordering Spare Parts
value was determined on a
2
0458-567-0121-B