Summary of Contents for SUPREME COMFORT SUPXX-C120D12
Page 1
INSTALLATION INSTRUCTIONS AND HOMEOWNER’S MANUAL: ELECTRIC FURNACE Models: COMFORT & ADVANTAGE OMFORT SUPXX-C120D12 SUPXX-C240D12 (PSC MOTOR) SUPXX-C120D20 SUPXX-C240D20 MULTI-POSITION DVANTAGE SUPXX-A120D12 SUPXX-A240D12 SUPXX-A120D20 SUPXX-A240D20 SUPXX-A2403D12 SUPXX-A2403D20 INSTALLER / SERVICE TECHNICIAN: Attention: USE THE INFORMATION IN THIS MANUAL FOR THE INSTALLATION AND SERVICING OF THE FURNACE AND Do not tamper with the unit or its controls.
WARNING Installation and repairs performed by unqualified SAFETY persons can result in hazards to them and to others. Installations must conform to local codes or, in the absence of such codes, to codes of the country having jurisdiction. The information contained in this manual is 1.1 DANGER, WARNING AND intended for use by a qualified technician, familiar CAUTION...
2.1 POSITIONING THE FURNACE IMPORTANT local national code requirements governing the installation of central electric heating equipment, wiring and the flue connection MUST be followed. Some of the codes WARNING that may apply are: ANSI/NFPA 70: National Electrical Code CSA FIRE AND EXPLOSION HAZARD C22.1 or CSA C22.10: Canadian Electrical Code The furnace must be installed in a level position,...
2.3.1 Upflow installation either suspended or on a combustible floor with a choice of right or left discharge, the clearances from combustible material must be adhered to. Refer to Figure 3 for The return duct may be installed to the back, to the additional details.
The exterior of the unit must have an uninterrupted Install the thermostat on an interior wall in a location ground to minimize the risk of bodily harm. A ground where it will not be subject to direct sunlight, lamps, terminal is supplied with the control box for that purpose. air diffusers, fireplaces, etc.
If longer heating cycles are desired, the anticipator can be set to a higher value Figure 8 – 1-stage thermostat, electric heating and air conditionning 2.5.2 Air ducts The ducts must be sized such a way as to accommodate the specified airflow and the available static pressure. Refer to the applicable local and/or national installation codes.
2.7.2 Use of a heat pump Table 1 – Supply air adjustment on cooling mode When using a heat pump, a thermostat with dual fuel MOTOR COOLING BLOWER BLOWER option or a fossil fuel kit is required that prevents the CAPACITY SPEED SPEED...
in the building. activating the compressor relay of the air The 15 A circuit breaker is there to protect the motor conditioner. and the control circuit conductors. If the unit does not function, press the circuit breaker button to see if it may 3.3.3 Continuous fan speed have disengaged due to a power surge.
Preventive maintenance is the best way to avoid CAUTION unnecessary expense and inconvenience. Have your heating system inspected by a qualified service technician once a year. Do not attempt to repair the It is important to check the airflow and to furnace or its controls.
Table 5 – Airflow (CFM) - SUPREME with 1/3 HP motor Furnace equipped with a 1/3 HP / 120 blower motor Blower External static pressure (inche of W.C.) Speed MED-LOW MED-HIGH 1 025 1 010 HIGH 1 260 1 240...
REVISIONS REV. DESCRIPTION DATE Figure 11 – Furnace dimensions 559mm 22" 25mm 1" SUPPLY 25mm ALIMENTATION 1" Identical on the 2 sides Identique sur les 2 cotés 559mm 22" 927mm 508mm x 508mm 36 1/2" 20" x 20" Identical on the 2 sides, the back and below.
Need help?
Do you have a question about the COMFORT SUPXX-C120D12 and is the answer not in the manual?
Questions and answers