modway EEI-798 Assembly Instruction

Black metal twin bed

E E I -798

BLACK METAL TWIN BED

Thank you for purchasing the MODWAY BED！！！！

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or

padded area, in the room that it is intended for. Approx assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or the instruction until you have checked all the components and

hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe

environmentally friendly way.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that has been provided.

6.Please keep all fitting out of reach of children.

Component:

Headboard

Side Rail with Slats

Customer Service 908-368-1025︱︱︱︱ www.modwayfurniture.com

Footboard

Support Leg

Bolt M6x60mm

Nut

Open Wrench

Allen Wrench

Page 1 of 2

Table of Contents

Need help?

Do you have a question about the EEI-798 and is the answer not in the manual?

Page 1 E E I -798 BLACK METAL TWIN BED Thank you for purchasing the MODWAY BED！！！！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions.
Page 2 E E I -798 BLACK METAL TWIN BED STEP 1: Place the 2pcs Side Rail with Slat (3) into 1pc Support Leg (4) as shown. Insert 2pcs Bolt (A) into the pre-drilled Holes on the Support Leg (4) through the pre-drilled holes on the Side Rail. Secure them by using 2pcs Nut (B) from the bottom of the Support Leg (4).