Section 1 − Installation And Operation; Safety Symbol Definitions; Software Licensing Agreement; Information About Default Weld Parameters And Settings - Miller RFCS-5 Owner's Manual

Foot controls

Hide thumbs Also See for RFCS-5:

Owner's manual (16 pages)

Owner's manual (12 pages)

Table Of Contents

Table of Contents

SECTION 1 − INSTALLATION AND OPERATION

1-1. Safety Symbol Definitions

DANGER! − Indicates a hazardous situation which, if not

avoided, will result in death or serious injury. The possible

hazards are shown in the adjoining symbols or explained

in the text.

DANGER ! - Indique une situation dangereuse qui, si elle

n'est pas évitée, entraînera la mort ou des blessures

graves. Les éventuels risques sont représentés par les

symboles joints ou expliqués dans le texte.

Indicates a hazardous situation which, if not avoided,

could result in death or serious injury. The possible ha-

zards are shown in the adjoining symbols or explained in

the text.

Indique une situation dangereuse qui, si elle n'est pas

évitée, entraînera la mort ou des blessures graves. Les

éventuels risques sont représentés par les symboles

joints ou expliqués dans le texte.

NOTICE Indicates statements not related to personal injury.

Signale des consignes non associées aux dommages

corporels.

Indicates special instructions.

Fournit des instructions spéciales.

Beware of electric shock from wiring. Disconnect input

power before installing this kit. Reinstall all panels and

covers.

Attention aux décharges électriques au contact des

câbles. Couper l'alimentation électrique avant d'installer

ce kit. Réinstaller tous les panneaux et couvercles.

CALIFORNIA PROPOSITION 65 WARNINGS

WARNING: Cancer and Reproductive Harm − www.P65Warnings.ca.gov

PROPOSITION CALIFORIENNE 65 AVERTISSEMENTS

AVERTISSEMENT : cancer et troubles de la reproduction − www.P65Warnings.ca.gov.

1-2. Software Licensing Agreement

The End User License Agreement and any third-party notices and terms and conditions pertaining to third-party software can be found at

https://www.millerwelds.com/eula

1-3. Information About Default Weld Parameters And Settings

NOTICE − Each welding application is unique. Although certain Miller Electric products are designed to determine and default to certain typical welding

parameters and settings based upon specific and relatively limited application variables input by the end user, such default settings are for reference

purposes only; and final weld results can be affected by other variables and application-specific circumstances. The appropriateness of all parameters

and settings should be evaluated and modified by the end user as necessary based upon application-specific requirements. The end user is solely

responsible for selection and coordination of appropriate equipment, adoption or adjustment of default weld parameters and settings, and ultimate

quality and durability of all resultant welds. Miller Electric expressly disclaims any and all implied warranties including any implied warranty of fitness

for a particular purpose.

Fsafe1 2013-10

Fsafe2 2013-10

Fsafe3 2013-10

Fsafe7 2013-10

and are incorporated by reference herein.

Arc rays can burn eyes and skin − wear a welding helmet

with correct filter, and cover exposed skin with nonflam-

mable clothing.

Le rayonnement de l'arc peut provoquer des brûlures au

niveau des yeux ou de la peau – porter un casque protec-

teur muni d'un écran de filtre approprié et porter des vête-