Advertisement
Storage
Warning:
Non-compliance with these steps might lead to residues in the carburettor leading to serious
starting problems or lasting damages after storing.
1.
Carry out all general maintenance work recommended in the "maintenance" section of the op-
erating manual.
2. Clean the outer surface of the device.
3. Empty the fuel out of the fuel tank.
4. Start the motor after the fuel has been emptied.
5. Let the motor run with idle-speed until the fuel remaining is consumed.
6. Let the motor cool down (approx. 5 min).
7. Use a spark plug wrench to remove the spark plug.
8. Add 1 teaspoon of clean 2-stroke oil into the combustion chamber. Pull the starter rope several
times slowly to lubricate the inner components. Re-place the spark plug.
9. Store the device in a cool, dry play, away from ignition sources such as oil burner, water heater,
etc.
Returning the device from storage
1.
Remove the spark plug.
2. Pull the starter rope quickly to remove the excess oil from the combustion chamber.
3. Clean the spark plug slot or install a new spark plug with an according slot.
4. Prepare the device before use.
5. Fill the fuel tank with the right fuel-oil mix (see "fuel and oil" section).
Troubleshooting
Problem
Device does not start or starts,
but does not work.
Device starts, but motor has low
output.
Motor does not start
No electricity supply under bur-
den
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Possible cause
Wrong starting procedure
Wrong carburettor mix
Dirty spark plug
Empty fuel tank
Primer pump pushed too often
Fuel filter clogged
Wrong lever position
Dirty fireguards
Dirty air filter
Wrong carburettor mix
Wrong carburettor mix
Clogged air filter
Old or wrongly mixed fuel
Item 61956
Possible solutions
Follow instructions in operating
manual.
Have carburettor adjusted by au-
thorised technician.
Clean slot or replace spark plug.
Fill fuel tank with properly mixed
fuel.
Push
primer
pump
slowly.
Replace fireguards.
Put lever in "run" position.
Replace fireguards.
Remove, clean, re-place filter.
Have carburettor adjusted by au-
thorised technician.
Have carburettor adjusted by au-
thorised technician.
Clean or replace air filter.
Empty fuel tank and fill it with
fresh fuel.
10 times
Page 14
12
2021-1
Advertisement
