Care And Cleaning Of Stainless Steel - Frigidaire Professional FPDF4085KF Important Safety Instructions Manual

care & cleaning

care and cleaning of stainless steel

Some models are equipped with stainless steel exterior
parts. Special care and cleaning are required for
maintaining the appearance of stainless parts. Refer
to the general care & cleaning table for detailed
cleaning instructions.
Removing and replacing the main oven
door (If equipped with hinge style A)
caution
The door is heavy. For safe, temporary storage, lay the
door flat with the inside of the door facing down.
To Remove Oven Door:
1. Open oven door completely (horizontal with floor -
See Figure 1).
2. Pull the door hinge locks on both left and right
door hinges down from the oven frame completely
towards the oven door (See Figure 2). A tool such as
a small flat-blade screwdriver may be required.
3. Firmly grasp both sides of oven door along the door
sides (Do not use the oven door handle - See Figure 3).
4. Close the door to the broil stop position (the oven door
will stop into this position just before fully closing).
5. With the oven door in the broil stop position, lift the
oven door hinge arms over the roller pins located on
each side of the oven frame (See Figure 4).
To Replace Oven Door:
1. Firmly grasp both sides of oven door along the door
sides (Do not use the oven door handle - See Figure 3).
2. Holding the oven door at the same angle as the
removal position, seat the hook of the hinge arm over
the roller pins located on each side of the oven door
frame (See Figure 4). The hook of the hinge arms
must be fully seated onto the roller pins.
3. Fully open the oven door (horizontal with floor - See
Figure 1).
4. Push the door hinge locks up towards and into the
oven frame on both left and right oven door hinges
(See Figure 2) to the locked position.
5. Close the oven door.
Door Hinge locations
with oven door fully open
Figure 1
30
Oven door
Removing and Replacing the main oven
door (If equipped with hinge style B)
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and
3. Grab the door by the sides, pull the bottom of the
4. To replace the door, reverse the door removal steps.
The door is heavy. After removing door, lay it flat on
the floor with its inside facing down.
Lock in normal
Special door care instructions -
doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are
2. Do not hit the glass with pots, pans, or any other ob-
3. Scratching, hitting, jarring or stressing the glass may
Figure 2
Around
Hinge
Figure 3
engage it in the hinge levers. You may have to apply
a little downward pressure on the door to pull the
locks fully over the hooks.
door up and toward you to disengage the hinge
supports. Keep pulling the bottom of the door toward
you while rotating the top of the door toward the
range to completely disengage the hinge levers.
Make sure the hinge supports are fully engaged
before unlocking the hinge levers.
caution
Lock engaged
position
for door removal
fully in place.
ject.
weaken its structure causing an increased risk of
breakage at a later time.
Figure 4
Hinge slot door removed
from the range
Most oven