Frigidaire Professional FPDF4085KF Important Safety Instructions Manual page 33

imPortant
Before you call for service, review this list. It may save you time and expense. The list includes common
occurrences that are not the result of defective workmanship or materials in this appliance.
occurrence
Range is not level.
Cannot move
appliance easily.
Appliance must
be accessible for
service.
Entire range or oven
does not operate.
Oven control beeps
and displays any F
code error (ex.: F10)
Oven light does not
work.
surface unit does
not heat.
surface burners do
not light.
surface burner
flame burns half
way around.
surface burner
flame is orange.
metalmarks.
BEFORE YOU CALL
POSSIBLE CAUSE/SOLUTION
Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust
leveling legs at base of range until the rack is level. When range is level, cooktop may
appear out of alignment if countertop is not level.
Weak, unstable floor. Be sure floor is level and can adequately support range. If floor is
sagging or slopping, contact a carpenter to correct the situation.
Kitchen cabinet misalignment may make range appear to be unlevel. Be sure cabinets are
square and have sufficient room for range clearance.
Cabinets not square or are built in too tight. Contact a cabinet maker to correct the problem.
Contact builder or installer to make appliance accessible.
Carpet interferes with range. Provide sufficient space so range can be lifted over carpet.
Make sure cord/plug is plugged tightly into outlet.
Service wiring is not complete. Call an authorized servicer.
Electrical power outage. Check house lights to be sure. Call your local electric company for
service.
Electronic control has detected a fault condition. Press cancel to clear the display and
stop beeping. Reprogram oven. If fault recurs, record fault number. Press cancel and call
an authorized servicer for assistance.
Replace or tighten bulb. See Changing Oven Light section in this Use & Care Guide.
Electrical power outage. Check house lights to be sure. Call your local electric company for service.
No power to the appliance. Check steps under "Entire Range or Oven Does Not Operate" in
this Before you Call checklist.
Incorrect control setting. Make sure the correct control is on for the surface unit to be used.
Surface control knob has not been completely turned to LITE. Push in and turn the surface
control knob to LITE (until burner ignites) and then turn the surface control knob to the
desired flame size.
Burner ports are clogged. Clean burners. See "To Clean Burner Grates, Contoured Burner
Pans, Burner Cap and Burner Base" under General Cleaning. With the burner off, use small-
gauge wire or needle to clean ports or slots.
Gas supply is turned off. Turn gas supply on.
Burner ports or slots are clogged. With the burner off, clean by using a small-gauge wire or
needle to lean ports or slots.
Moisture is present after cleaning. Lightly fan the flame and allow the burner to operate
until flame is full. Dry the burners thoroughly following instructions under General Cleaning.
Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.
Salt air in coastal areas. A slightly orange flame is unavoidable.
Sliding or scraping of metal utensils on cooktop surface. Do not slide metal utensils on
cooktop surface. Use a ceramic-glass cooktop cleaning cream to remove the marks.
"Cooktop Cleaning - Ceramic Glass Cooktop Models" section under General Cleaning.
(solutions to common Problems)
33