Power Supply; Overview; Front View; Rear View - Philips GoPix 1 User Manual

Power supply

Use only a PD charger which is certified for this
product (see Technical data, page 16).
Check whether the mains voltage of the power
supply matches the mains voltage available at
the setup location. This product complies with
the voltage type specified on the product.
The power outlet shall be installed near the
product and shall be easily accessible.
The capacity of the built-in battery diminishes
with time. If the product functions only with AC
power supply, the built-in battery is defective.
Contact an authorised service centre to replace
the built-in battery.
CAUTION!
Always use the
projector off.
Turn off the product and unplug from the
power outlet before cleaning the surface
(see Cleaning, page 13). Use a soft, lint-
free cloth. Never use liquid, gaseous or easily
flammable cleaners (sprays, abrasives, polishes,
alcohol). Do not allow any moisture to reach
the interior of the product.
DANGER!
Risk of eye irritation!
This product is equipped with a high
power LED (Light Emitting Diode),
which emits very bright light. Do not
look directly into the projector lens
during operation. This could cause eye
irritation or damage.

Overview

button to turn the
2 Overview

Front view

b
a
Focus adjustment knob
a
Adjust image sharpness.
Projection lens
b

Rear view

USB-C USB-C
Power Video
a c
b
IR sensor
a
b
Connect to the power supply via a USB-C
PD (Power Delivery) charger.
Power supply needs to be at least 12 V.
port
c
• Connect to the USB-C video output on
a playback device (e.g., a mobile phone,
tablet or laptop). The device must be
compatible with USB-C video output.
• USB storage devices for firmware
upgrade.
port
d
Connect to the HDMI output on a playback
device.
LED indicator
e
• When the projector is switched on, the
LED turns white.
• When the projector is in standby, the
LED turns red.
f
• Press and hold for 1 second to switch
the projector on.
• Press twice to switch the projector off.
Mini
HDMI
f
d e
port
5