Table of Contents
Advertisement
6
EN
How To Attach The Core Filter
Attach the Core Filter(s) (if provided with your model
interference.
1
Stopper
Release the
stoppers on both
ends of the Core
Filter.
When connecting cables, attach the end with the Core Filter to the camcorder.
Automatic Demonstration takes place when "DEMO MODE"
is set to "ON" (factory-preset).
Available when the Power Switch is set to "
cassette is in the camcorder.
Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for more
than 1 minute after that, the demonstration will resume.
"DEMO MODE" remains "ON" even if the camcorder power is
turned off.
To cancel Automatic Demonstration:
1. Set the Power Switch to "
Button located on the switch and press the MENU/BRIGHT
wheel in. The Menu Screen appears.
2. Rotate the MENU/BRIGHT wheel to select "
press it. The SYSTEM Menu appears.
3. Rotate the MENU/BRIGHT wheel to select "DEMO MODE" and
press it. The Sub Menu appears.
4. Rotate the MENU/BRIGHT wheel to select "OFF" and press it.
5. Rotate the MENU/BRIGHT wheel to select "1RETURN", and
press it twice. The normal screen appears.
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes
of the Automatic Demonstration activated on the LCD monitor or
viewfinder.
2
3 cm
Run the cable through the Core Filter, leaving approx.
3 cm of cable between the cable plug and the Core
Filter. Wind the cable once around the outside of the
Core Filter as shown in the illustration.
•Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
AUTOMATIC DEMONSTRATION
" while pressing down the Lock
pg. 5) to an optional cable(s). The Core Filter reduces
Wind once
" or "
" and no
SYSTEM" and
3
Close the Core Filter until it
clicks shut.
MENU/BRIGHT Wheel
Lock Button
Power Switch
Sub Menu
DEMO
MODE
–
OF F
ON
GR-DVL915/DVL715/DVL515
only
Advertisement
Table of Contents
