Advertisement
Operating Instructions
Operating Instructions
NOTE
The following instructions represent the Touch Pad, the same instructions can be used for the Remote Control.
TO TURN UNIT ON:
Note: The unit will run in energy saver mode when used for the first time. In this mode, the fan will continue to run for 1
minute after the compressor shuts off. The fan then cycles on for 20 seconds at 10 minute intervals until the room tempera-
ture is above the set temperature, at which time the compressor turns back on.
TO CHANGE TEMPERATURE SETTlNG:
Note: Tap or hold either up (
will be automatically maintained anywhere between 60 °F (16 °C) and 90 °F (32 °C) for cooling mode. The temperature will
be automatically maintained anywhere between 55 °F (13 °C) and 80 °F (27 °C) for heating mode. If you want the display to
read the actual room temperature. See "To Operate on Fan Only" section on this page.
TO ADJUST FAN SPEEDS:
Note: Fan starts at High Speed and adjusts to a slower speed as the room temperature dictates. For example, if the room
doesn't get too warm,it will stay at the slowest speed. If the room temperature rises quickly, such as a door being opened,it
will automatically goto the highest speed. The fan speeds will re-adjust back to the slowest speed as the room returns to the
original set temperature. Press either the fan slower or fan faster button to adjust the fan speed manually.
6
DO THIS:
PRESS ON/OFF
BUTTON
DO THIS:
PRESS TO RAISE
PRESS TO LOWER
) or down (
) button until the desired temperature is seen on the display. This temperature
DO THIS:
PRESS SPEED
BUTTON
YOU WILL SEE:
YOU WILL SEE:
YOU WILL SEE:
Advertisement
