Operating Your Air Conditioner; Starting Your Air Conditioner - Crosley CA18WCK0 Use And Care Manual

Operating Your Air Conditioner

EN
Operating your air conditioner properly helps you to obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
• If you turn the air conditioner off, wait at least 3 minutes before turning it back on. This prevents the air conditioner from
blowing a fuse or tripping a circuit breaker.
• Do not try to operate your air conditioner in the cooling mode when outside temperature is below 65°F (18°C). The
inside evaporator coil will freeze up and the air conditioner will not operate properly.

Starting your air conditioner

1. Set the EXHAUST Control (some models) to
CLOSED for maximum continuous cooling. The
EXHAUST Control allows you to draw stale or
smoky air from the room.
OPEN - to exhaust room air to the outside.
CLOSED - to circulate room air.
The EXHAUST Control will function only when FAN
CONTROL is operating.
2. Set the FAN CONTROL to the desired setting.
When the air conditioner is operating at LOW
COOL, HIGH COOL (some models), or TURBO
COOL, the fan circulates air continuously.
TURBO COOL - for maximum cooling
HIGH COOL (some models) - for normal
cooling
LOW COOL - for sleeping comfort
FAN ONLY
When the FAN ONLY setting is selected, the fan will
run continuously to move air, but the air will not be
cooled.
POWER SAVER (some models)
When the air conditioner is operating on POWER
SAVER, the fan runs only when cooling is needed.
The fan stops circulating air when the room
temperature matches the THERMOSTAT Control
setting.
Since the fan does not circulate the room air
continuously, less energy is used but the room air is
not circulated as often. Use POWER SAVER when
you are away from home or asleep.
HEAT/COOL AIR CONDITIONER HEAT
SETTINGS
TURBO HEAT - for maximum heating
HIGH HEAT - for normal heating
LOW HEAT - for reducing heating
FAN ONLY (some models) - for circulating air
without heating or cooling
CLOSED OPEN
EXHAUST
Your air conditioner has one of these controls:
OFF
FAN TURBO
FAN CONTROL
ONLY COOL
LOW
COOL
OFF
FAN
TURBO
ONLY
COOL
FAN CONTROL
HIGH
LOW
COOL
COOL
FAN
ONLY
OFF
POWER
SAVER
LOW
FAN CONTROL
COOL
HIGH
COOL
TURBO
COOL
OFF
TURBO TURBO
HEAT COOL
HIGH HIGH
FAN CONTROL
HEAT COOL
LOW
LOW
COOL
HEAT
FAN
ONLY
5