Beep Will Sounds And Pf Will Disappear - Frigidaire GLES388DSB Control Manual

Setting the Clock
Setting the Clock
The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the timer
in the display will flash with "PF" (power failure, See Figure 1).
When PF appears in the display, press
beep will sounds and PF will disappear.
INSTRUCTIONS
To set the clock (example below for 1:30):
1. Press . "CLO" will appear in the display (Figure 2).
2. Press pads to set the time of day to 1:30 (Figure 3).
"CLO" will appear in the display. Press
disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold
pad down the current time of day will remain and "CLO" will
disappear from the display (Figure 4). CONTINUE holding the pad
until a beep is heard.
2. The display will show either "12Hr" (Figure 5) or "24Hr" (Fig.6).
3. Press to switch between the 12 and 24 hour time of day
display. The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure 6).
4. Press to accept the change or press
change.
5. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
No sound will be heard, but after 10 seconds a
.
for 6 seconds (Figure 3). While holding the
Push buttons or pads may be shaped differently.
. "CLO" will
to reject the
2
PRESS
for 6 seconds
or
Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6