Filling The Water Tank - Dyson Purifier Humidify+Cool User Manual

Filling the water tank

Before you remove the water tank, make sure humidification modes are
turned off and the water tank is empty.
Keep the cap dry
Keep the cap on the water tank dry when you run a Deep clean cycle or fill
the tank. It contains power connections and should not be washed. If wet,
wipe thoroughly with a dry cloth. Make sure the cap and connections are
completely dry before refitting.
Remove the tank
Push down the Water tank release buttons on the sides of your machine.
Slide the water tank out of your machine.
Carry the water tank by its handle to the tap, and unclip the cap.
Fill the tank
Fill the water tank to the Max level with cold tap water.
Replace the tank
Replace the cap and secure the cap clips in place.
Make sure the cap is completely dry. If wet, wipe thoroughly with a dry cloth.
Slide the water tank back into your machine until it clicks securely in place.
The water tank cap has two lips either side that
can be pulled upwards to release the cap.
MAX level