Step 1: Unpack And Inspect The Module; Esd; Inspect For Damage - Keysight Technologies M9035A Startup Manual

Step 1: Unpack and Inspect the Module

ESD

Electrostatic discharge (ESD) can damage or destroy electronic components. All
work on electronic assemblies should be performed at a static-safe work station.
The following figure shows an example of a static-safe work station using two
types of ESD protection. Purchase acceptable ESD accessories from your local
supplier.
- Conductive table-mat and
- Conductive floor-mat and
Both types, when used together,
provide a significant level of ESD
protection. Of the two, only the
table-mat and wrist-strap
combination provides adequate
ESD protection when used alone.
To ensure user safety, the
static-safe accessories must
provide at least 1 M of isolation
from ground.

Inspect for Damage

After unpacking the embedded controller, carefully inspect it for any shipping
damage. Report any damage to the shipping agent immediately, as such
damage is not covered by the warranty.
12
Keysight's PXIe Modules are shipped in materials that prevent
static electricity damage. The modules should only be removed
from the packaging in an anti-static area ensuring that correct
anti-static precautions are taken. Store all modules in anti-static
envelopes when not in use.
wrist-strap combination.
heel-strap combination.
To avoid damage when handling a module; do not touch exposed
connector pins.
Step 1: Unpack and Inspect the Module
Keysight M9035A PXIe Embedded Controller Startup Guide