Paradox SP6000 Programming Manual page 4

Data Entry and Display
To access the data display mode, access the desired section and press
configured to your system, specific LEDs or icons will flash, thus indicating that you are in data display mode. Each time
pressed, the keypad will display the next digit in the current section, and will continue to do so through all the remaining sections,
one digit at a time, without changing the programmed values; this is not available for sections using the multiple feature select
method. Press at any time, to exit data display mode.
CLEAR
There are two methods that can be used to enter data when in programming mode: single digit data entry and feature select
programming.
Single Digit Data Entry Method
After entering programming mode, some sections will require you to enter decimal values from 000 to 255. Other sections will
require that you enter hexadecimal values from 0 to F. The required data will be clearly indicated in this guide. When entering the
final digit in a section, the panel will automatically save and advance to the next section. See Decimal and Hexadecimal
Programming for details on the various keys, and their equivalent decimal and hexadecimal values.
Feature Select Programming Method
After entering certain sections, eight options will be displayed. In these instances, each option (from 1 to 8) represent a specific
feature. To turn enable the option, press the key corresponding to the desired option. Press the key again to remove the digit,
thereby, disabling the option. Press
and advance to the next section.
Viewing Version Numbers
Table 1: Viewing panel and keypad version numbers
Step Action
Enter viewing mode:
• For panel version, enter section [980]
1
• For keypad version, enter installer programming,
then press and hold
2 Press
ENTER
3 Press
ENTER
4 Press
ENTER
01.42
Example: Version
NOTE: For keypads K10V/H and K636, the keypad version numbers cannot be viewed.
Decimal and Hexadecimal Programming
Table 2: Decimal and hexadecimal values for 10 and 32-Zone LED keypads
Value or Action
Value 0/replace current
digit with 0
Values 1 to 9
A (hex only)
B (hex only)
C (hex only)
D (hex only)
E (hex only)
F (hex only)
Exit without saving
Save data (hex only)
EN 50131 Compliancy
To have your panel compliant with EN 50131 standards, see Appendix A on page 68. Please note that Installer Quick Menu
Programming is not available on MG5050 version 4.96 and higher.
4
to disable all eight options. When the options are set, press
SLEEP
Details
The first digit is displayed
(usually 0)
ARM
The second digit is displayed
The third digit is displayed
The fourth digit is displayed
Digits 1-4
Key
32-Zone LED
Erase digit and remain in section
SLEEP
1 to 9
0
OFF
BYP
MEM
TBL
Arm and Stay LEDs flash
CLEAR
Advances to next section
ENTER
before entering any data. Depending on the keypad(s)
ENTER
Result
Erase digit and remain in section
Zone 1 to 9
Zone 10
Zone 11
Zone 12
Zone 13
Zone 14
Zone 15
ENTER
When Viewing Keypad Version
Digit 1: is illuminated
ARM
Digit 2: is illuminated
SLEEP
Digit 3: is illuminated
STAY
Digit 4: is illuminated
OFF
10-Zone LED
Keys 1 to 9
Key 0 (10)
OFF
BYP
MEM
TBL
Arm and Stay LEDs flash
Advances to next section
is
ENTER
to save your settings