Playing Back With The Built-In Speaker/Headphones - Canon optura300 Instruction Manual

Playing Back with the Built-in Speaker/Headphones

E
❍ When using the built-in speaker, make sure that "H" is not displayed on the
screen. When using the headphones, make sure that "H" is displayed. Change
the setting as necessary (
❍ The built-in speaker does not sound when "H" is displayed.
❍ Do not connect headphones unless "H" is displayed as it produces noise.
❍ The built-in speaker is monaural. Use headphones for stereo sound.
❍ The setting has to be done separately for each operating mode. Make sure to
change the setting when you have change the operating mode.
Adjusting the Volume
CAMERA
Turn the selector dial up to increase the volume, and
down to lower the volume.
• A volume bar appears for 2 seconds.
• You can turn off the volume completely by turning the selector
dial down until [OFF] appears. Turn the selector dial up to increase
the volume again.
❍ Sound may become distorted when the volume is turned up too high.
❍ The camcorder retains the setting even if you turn it off (separately for
headphones and built-in speaker).
❍ See also
38
Built-in speaker
PLAY (VCR)
Using Headphones during Recording (
AV IN/OUT
74).
CARD CAMERA
Selector dial
H (phones) terminal
CARD PLAY (VCR)
74).