Changing The Remote Sensor Mode - Canon optura300 Instruction Manual

Changing the Remote Sensor Mode

Two remote sensor modes and an off setting are available to prevent interference
E
from other Canon wireless controllers being used nearby.
Turning the Remote Sensor Off
CAMERA
SYSTEM
( 42)
Open the menu and select [SYSTEM]. Select [WL.
REMOTE], set it to [OFF B] and close the menu.
"B" appears.
Changing the Remote Sensor Mode
CAMERA
SYSTEM
( 42)
1. On the camcorder, open the menu and select
[SYSTEM]. Select [WL. REMOTE], set it to [A 2] and
close the menu.
The selected mode appears for a few seconds.
2. On the wireless controller, press and hold the
REMOTE SET button. Press the ZOOM
mode 2. Keep the button pressed for over 2 seconds.
If you have set the camcorder to mode 1, press the ZOOM
button for mode 1.
❍ The wireless controller returns to mode 1 when you replace the batteries.
Change the mode if necessary.
❍ Make sure that camcorder and wireless controller are set to the same mode.
Display the camcorder's mode by pressing any button on the wireless controller
(except of the REMOTE SET button) and set the wireless controller's mode to
the same mode. Change the batteries if the wireless controller still does not
48 work.
PLAY (VCR)
WL.REMOTE••••
PLAY (VCR)
WL.REMOTE••••
CARD CAMERA
1
CARD CAMERA
1
T
button for
W
CARD PLAY (VCR)
CARD PLAY (VCR)
×
2
AUDIO DUB. PAUSE SLOW
MENU SET
AV INSERT AV DV
REMOTE SET
START
ZOOM
/STOP
PHOTO W T
SELF T.
SEARCH SELECT