Hearth and Home Technologies PHFR-MCE-36 Installation Instructions Manual page 8

10. Locate the finishing trim piece and break at the two
places noted in Figure 5.12. Bend as indicated in Fig-
ure 5.13, Detail A, B, and C.
BREAK HERE
LEFT
OR RIGHT
LEFT
OR RIGHT
BEND HERE
BEND HERE
Figure 5.12 Finishing Trim
DETAIL A DETAIL A
DETAIL C DETAIL C
Figure 5.13 Break and Bend Finishing Trim
8 Hearth & Home Technologies • PHFR-MCE-36, PHFR-MCE-48, PHFR-MCE-60, PHFR-MCE-72 Instructions • 2560-972 • 6/20
BREAK HERE
CENTER FINISHING TRIM
BEND HERE
BEND HERE
DETAIL B DETAIL B
11. Install the left and right finishing trim pieces on the
framing on the sides of the discharge opening using
construction screws or nails as shown in Figure 5.14,
Detail A and B. Notice that the screws are installed
on the back side of the framing. See Figure 5.14 and
Figure 5.29.
DETAIL A - FRONT DETAIL A - FRONT
Figure 5.14 Finishing Trim Installed
12. Two passive heat plenums are included with the kit
and both must be installed with the appliance or the
appliance will overheat. The plenums are placed into
the framed opening from inside the chase.
WARNING! Risk of Fire! Two plenums MUST be in-
stalled for passive heat to function correctly. Overheating
of appliance and combustible materials will occur.
13. Position the first plenum into the wall by turning verti-
cally to clear the studs. See Figure 5.15.
Figure 5.15 Turn Plenum Vertically to Clear Framing Studs
14. Turn plenum back to horizontal orientation and tilt to
bring bottom nailing tabs through the opening first.
Rotate the plenum forward to get the top nailing tabs
through. See Figures 5.16, 5.17, and 5.18.
DETAIL B - BACK DETAIL B - BACK