Hearth and Home Technologies PHFR-MCE-36 Installation Instructions Manual page 11

WARNING! Risk of Fire! DO NOT fold/kink/pinch/ob-
struct 6 inch flexible ducts. Overheating of appliance and
combustible materials will occur.
20. Cut flex venting to appropriate length to run from top
of appliance to the bottom of the plenum. Ensure
there are no kinks. See Figure 5.26 and Figure 5.27.
21. Secure flex venting to collars on both the appliance
and the bottom of the plenum using the provided gear
clamps. See Figure 5.27 and Figure 5.29.
Figure 5.26 Install Flex Venting to Collar on Bottom of Plenums
Figure 5.27 Install Flex Venting to Appliance
Hearth & Home Technologies • PHFR-MCE-36, PHFR-MCE-48, PHFR-MCE-60, PHFR-MCE-72 Instructions • 2560-972 • 6/20
22. Install self-tapping screw through gear clamp into col-
lar. Repeat for all collars. See Figure 5.28
Figure 5.28 Install Screw into Collar
BACK SIDE: LOCATION OF BACK SIDE: LOCATION OF
FINISHING TRIM PIECE FINISHING TRIM PIECE
(See Figure 5.14.) (See Figure 5.14.)
Figure 5.29 Flex Vent Installed with No Kinks
SCREW SCREW
11