Porkka Inventus Installation And Operation Manual page 9

Cleaning
Clean spillages immediately.
Ensure effective operation of the equipment and the quality of the products being stored, by
defrosting and cleaning the equipment regularly, we recommend at least once per month.
Remove all products and store them in a back-up store.
Switch off the cabinet from the main electrical supply by removing cable and plug from the
wall socket.
Remove the shelves.
Wash the stainless steel surfaces of the cabinet with a mild detergent mixed with water, e.g.
dishwasher detergent or other suitable food safe cleaning product. Use a cloth or paper towel
to prevent scratching the steel surface.
Wipe with down with a cloth and allow the cabinet to dry.
Note!
Do not use detergents or disinfectants containing chlorine i.e. bleach, solvents, scouring
products, or a knife or other sharp tools when cleaning.
Note!
Do not use running water to wash the cabinet.
Note!
Refer to the product description of the disinfectant to see which materials it is suitable for.
Do not let it splash on sensitive parts, such as thermostat regulator or door hinges. Dry the
equipment after the disinfection and let it ventilate.
To clean the condenser and or condenser filter:
Switch off the cabinet from the main electrical supply by removing cable and plug from wall
socket. The condenser is situated on the right hand side of the machine compartment of the
cabinet when facing the front, (1). Remove the knurled - head screw on the lower part of
the top front panel, then pivot the panel upwards on it's hinges until it is secure, leaving the
machine compartment open. Take care that the panel will not fall back and cause injury.
Push the filter holding bracket (2) down from the top until it becomes free, then swing to
the right, when you can then remove the filter and or use a dry brush or vacuum cleaner to
remove dust from condenser fins.
Was the filter with e.g. liquid detergent, rinse the filter and let it dry, and then put replace.
Switch that cabinet on only when the front cover has been replaced in position and screw is
back in place.
1. 3.
2.
8
ENGLISH