Canon Optura S1 Instruction Manual page 131

Message
COULD NOT PRINT X
IMAGES
SET PRINT ORDER
CANNOT TRIM
READJUST TRIMMING
PRINTER ERROR
PRINT ERROR
HARDWARE ERROR
RECHARGE THE
PRINTER BATTERY
COMMUNICATION
ERROR
CHECK PRINT
SETTINGS
PRINTER IN USE
PRINTER WARMING UP
PAPER LEVER ERROR
PRINTER COVER OPEN
NO PRINTHEAD
You attempted to use the print order settings to print X images that were
recorded with another camcorder, with a different compression or were
edited on a computer.
No still images on the memory card have been marked with a
order.
You attempted to trim an image that was recorded with another
camcorder.
You changed the print style after you set the trimming settings.
Cancel printing. Turn off the printer and turn it back on. Check the printer
status. If the error persists, consult your dealer or a Canon Service
Center listed in the Contact List provided with the printer or the printer
manual.
Cancel printing, disconnect the USB cable and turn off the printer. After a
while, turn the printer back on and reconnect the USB cable. Check the
printer status. If the error persists, consult your dealer or a Canon
Service Center listed in the Contact List provided with the printer or the
printer manual.
When you are printing using the
Cancel printing. Turn off the printer and turn it back on. Check the printer
status. If the printer is equipped with a battery, it might be exhausted. In
such case, turn off the printer, replace the battery and turn it back on. If
the error persists, consult your dealer or a Canon Service Center listed in
the Contact List provided with the printer or the printer manual.
The printer battery is depleted.
The printer is experiencing a data transmission error. Cancel printing,
disconnect the USB cable and turn off the printer. After a while, turn the
printer back on and reconnect the USB cable. When you are printing
using the button, check the print settings.
Or, you attempted to print from a memory card that contains a large
number of images. Reduce the number of images.
The print setting cannot be used for printing with the
The printer is in use. Check the printer status.
Printer is warming up. If the message does not disappear after a few
seconds, check the printer status.
Paper lever error occurred. Adjust the paper selection lever to the proper
position.
Close the printer cover securely.
No print head is installed in the printer or print head is defect. Refer to the
instruction manual of your printer.
Explanation
button, check the print settings.
E
print
button.
131