Daewoo DWC-UD1222 Instruction Manual page 13

3. HEAVY STAIN PROGRAM
Put the laundry into the Drum and put the detergent and softerner into the detergent
case.
Then close the Door.
• Put the detergent into the main wash room(I I marking) and prewash room(I marking)
1
in the detergent case.
• Softener should be below 'MAX' level.
• When you want to use bleach, put it into the main wash room (I I marking) with
detergent.
Press the Power button.
2
• The LED shows only '- --' signal.
Select the 'HEAVY STRAIN' program using the program selection dial.
• If you press 'Start/Pause' button aftrer pressing Power button without selecting
program, the 'NORMAL' program is selected as default program.
• 'Pre wash' and '3' times rinse and 'Medium' spin speed and '40°C' water temperature
3
are selected automatically.
• If you want to change the 'Washing course' and 'Rinse time(s)' and 'Spin speed' and
'water temperature', select program what you want to change by pressing each
button.
Press the 'Start/Pause' button.
4
• The washer will be operated with locking Door and supplying water.
Note
• If you want to change the setting program during operation, press the 'Start/Pause' button to hold the
operation and change the program you want to change by pressing each corresponding button.
• Water temperature '95°C' is not selected in order to prevent clothes from damaging.
• If you want to add the clothes during operation, press 'Start/Pause' button and 'Door unlock' button, then
open the Door and put the clothes into the Drum and then close Door and press 'Start/Pause' button again.
13