Daewoo DWC-UD1222 Instruction Manual page 12

2. WHITES PROGRAM
Put the laundry into the Drum and put the detergent and softerner into the detergent
case
Then close the Door
• Put the detergent into the main wash room(I I marking .
1
• Softener should be below 'MAX' level.
• Put the detergent into the pre wash room(I marking) only if you want to add prewash.
• When you want to use bleach, put it into the main wash room (I I marking) with
detergent
Press the Power button
2
• The LED shows only '- --' signal
Select the 'WHITE' program using the program selection dial.
• If you press 'Start/Pause' button aftrer pressing Power button without selecting
program, the 'NORMAL' program is selected as default program.
3
• 'Main wash' and '3' times rinse and 'Medium' spin speed and '95°C' water
temperature are selected automatically.
• If you want to change the 'Washing course' and 'Rinse time(s)' and 'Spin speed' ,
select program what you want to change by pressing each button.
Press the 'Start/Pause' button.
4 • The washer will be operated with locking Door and supplying water after sensing the
amount of laundry automatically.
Note
• If you want to change the setting program during operation, press the 'Start/Pause' button to hold the
operation and change the program you want to change by pressing each corresponding button.
• Water temperature is set only to '95°C'.
• If you want to add the clothes during operation, press 'Start/Pause' button and 'Door unlock' button, then
open the Door and put the clothes into the Drum and then close Door and press 'Start/Pause' button again.
• If much SUDS is happened during operation, the washer will clean SUDS automatically.
12