SAFEMATIC ST-1440 Manual page 18

Display function keys
Key
Chnl
Set
Esc
Configuration settings
Note
Each channel can be set to different operation modes regardless of the settings of the other
channel.
Display code
SG1
SG2
SG2E
OS
ML1
ML2
The channels can be divided into two groups (Group 1 / Group 2). Channels in different
groups can be pressurized simultaneously.
Channel line and pump control are switched on at the set pump control channel.
The channel-specific alarm relay can be set as alarm (Relay 0) or status output (Relay 1).
The pressure control unit can selected to be pressure transmitter (P-transm.) or pressure
switch (P switch).
The center specific configuration settings include
•
display language
•
date and time
•
delay multiplier, factory setting = 3
•
pressure unit
14402BEN.doc
Description
Channel selection
Press key to display the configuration settings for the next channel.
Channel can also be selected with
between channel up and down.
Configuration mode
Press key to go into configuration settings mode in which you can change the
configuration settings for the selected channel. The program requires a separate
password before it accepts this command.
Back to basic display
Press key to return to the basic display.
Configuration settings should be changed only when changes are made to
the system, for example, additional channels and pumping centers are
installed. These changes are usually implemented by the supplier.
Configuration mode requires a password 1441.
Selected operation mode
Single line grease lubrication channel
Dual line grease lubrication channel
Dual line grease lubrication channel,
pressurization maintaining operation
oil lubrication channel
Single line MultiLube
Dual line MultiLube
SAFEGREASE, SAFEOIL, MULTILUBE
ST-1440
and keys, which can used for toggling
17 (19)
12.11.2004 Rev. 2B