Settings Mode - SAFEMATIC ST-1440 Manual

Display function keys
Key
Chnl
Othr
Set
Esc

4.3 Settings mode

The settings for the selected channel can be displayed by selecting Page - Set at basic display.
The program requires a password before it accepts this command.
----
Figure 9.
Use keypad to enter a four-digit password (1440). Press OK to accept the entered password,
and the system goes into settings mode. A digit can be deleted using the <--- key. If the
entered password is not correct, you will be prompted to enter the correct password.
CH12 SG2 Machine 1
Tc=024h00min P=0230s
Hp=120bar Lp=050bar
----
Figure 10.
The flashing cursor indicates the field to be set. Use keypad to enter the value. Press OK to
save the entered value, and the cursor moves on to the next field to be set.
14402BEN.doc
Description
Channel selection
Press key to display the settings for the next channel.
Channel can also be selected with
between channel up and down.
Other displays
Press the key to open a display in which you can choose lubrication counter
display or configuration display.
Settings mode
Press key to go into settings mode in which you can change the settings for the
selected channel. The program requires a password before it accepts this
command.
Back to basic display
Set Password
0000
OK <--- Esc
Entering password
OK ---- Esc
Settings mode
SAFEGREASE, SAFEOIL, MULTILUBE
ST-1440
and keys, which can used for toggling
14 (19)
12.11.2004 Rev. 2B