Advertisement
Step 15
W28 ctr
(38)
1
Install a left roof panel at the left
rear and right front corner of the roof.
Install a right roof panel at the left
front corner of the roof.
2
Cut 2 short 2" (5,1 cm) strips o
the roll of weather stripping tape,
and put them aside. Cover the joint at
the peak with weather stripping tape.
Unroll the tape and press it down over
the opening at the ridge as you install
each roof panel. Do not cut the tape
at this time.
3
Install 4 roof panels in the se-
quence and positions shown on previ-
ous page. Do not fasten the lower end
of the panels to the side wall angles
at this time. Continue weather strip-
ping the ridge opening. Fasten roof
panel overlaps not used for ridge cap
(roof center). Cover the head of bolt
with the 2" (5,1 cm) piece of weather
stripping tape.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
(23)
Parts Needed For
Roof Assembly
STEP
8467 Left Roof Panel
1
8466 Right
Roof Panel
Screws To
Roof Beam
Fasten At
Overlap with
Bolt
Screws To
Roof Beam
Do not fasten
at this time
Cut
Weather Stripping
and Fold Under
28
8467 Left Roof Panel (2)
7875 Roof Panel (4)
8466 Right Roof Panel (1)
Weather Stripping
Tape Roll
7875 Roof Panel
STEP
3
Fasten At
Overlap with
Bolt
Strips
STEP
2
Advertisement
