List Of Messages - Canon HV10 Instruction Manual

76 Trouble?
Printing
Problem
The printer is not operating
even though the camcorder
and printer are correctly
connected.
Editing
Problem
Cannot record with this
camcorder video input from an
external video device
connected to the HDV/TV
terminal using a DV cable.
Others
Problem
A rattling can be heard from the
camcorder.

List of Messages

Message
SET THE TIME ZONE,
DATE AND TIME
CHANGE THE BATTERY
PACK
THE TAPE IS SET FOR
ERASURE PREVENTION
REMOVE THE CASSETTE
CHECK THE HDV/DV
INPUT
(Appears only if a DV cable is
connected)
CONDENSATION HAS
BEEN DETECTED
CONDENSATION HAS
BEEN DETECTED
REMOVE THE CASSETTE
TAPE END
Disconnect the USB cable and turn off the camcorder and the
printer. After a short while, turn them on again, set the
camcorder to
Set [AV DV] to [OFF].
Wrong signal standard. Dubbing may work using the AV IN/OUT
terminal.
Refer also to the instruction manual of the connected device.
The internal lens fixture can move when the camcorder is turned
off. This is not a malfunction.
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the time
zone, date and time.
Battery pack is exhausted. Replace or charge the battery pack.
Cassette is protected. Replace the cassette or change the position
of the protect switch.
Camcorder stopped operating to protect the tape. Remove the
cassette and reinsert it.
The DV cable is not correctly connected to the HDV/DV terminal, or
the connected digital device is turned off.
The video input signal is in a different television system (PAL or
SECAM).
Condensation has been detected in the camcorder.
Condensation has been detected in the camcorder. Remove the
cassette.
Tape reached the end. Rewind the tape or replace the cassette.
Solution
mode and restore the connection.
Solution
Solution
Explanation/Solution
–
33
–
–
24
18
80
19
57
–
82
82
–