Canon HV10 Instruction Manual page 77

Message
INCORRECT TAPE
SPECIFICATION
INPUT SIGNAL NOT
SUPPORTED
PLAYBACK STD LOCKED
INCOMPATIBLE VIDEO
INPUT
PLAYBACK STD LOCKED
PLAYBACK IS
RESTRICTED
HEADS DIRTY, USE
CLEANING CASSETTE
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED
COPYRIGHT PROTECTED
DUBBING RESTRICTED
NO CARD
NO IMAGES
CARD ERROR
CARD FULL
IN CARD POSITION
NAMING ERROR
UNIDENTIFIABLE IMAGE
TRANSFER ORDER
ERROR
PRINT ORDER ERROR
CANNOT TRANSFER!
TOO MANY STILL IMAGES
DISCONNECT USB CABLE
You attempted to play back a tape recorded in a different television
system (PAL or SECAM) or in a recording standard not supported
by this camcorder.
The digital device connected with the DV cable is incompatible with
the camcorder.
Current camcorder settings do not match the HDV/DV standard of
the video input signal. Change the [PLAYBACK STD] setting to
match the video input signal.
Current camcorder settings do not match the HDV/DV standard of
the recording you tried to play back. Change the [PLAYBACK STD]
to match the recording standard of the tape.
Video heads are dirty. Clean the video heads.
You attempted to play back a copyright protected tape.
You attempted to dub a copyright protected tape. May also appear
when an anomalous signal is received during analog line-in
recording.
Memory card not is inserted into the camcorder.
No images are recorded on the memory card.
A memory card error occurred. The camcorder cannot record or
display the image.
The error may be temporary. If the message disappears after 4
seconds and " " flashes red, turn the camcorder off, remove the
card and reinsert the card. If "
continue recording/playback.
Memory card is full. Erase some images to free some space or
replace the memory card.
Start/Stop
You pressed while recording still images (
mode).
The folder and file numbers have reached their maximum value.
Set the [FILE NOS.] option to [RESET] and erase all the images on
the memory card or initialize it.
The image file is corrupted or it was saved using a compression
method other than that compatible with this camcorder (JPEG).
You attempted to set more than 998 transfer orders.
You attempted to set more than 998 still images in the print order.
You attempted to transfer a still image that cannot be displayed with
this camcorder.
Disconnect the USB cable and decrease the number of still images
on the memory card to less than 1800. If a dialog appeared on the
computer screen, close it and then restore the connection.
Explanation/Solution
" changes to green, you can
Trouble? 77
E
–
–
34
34
82
62
62
20
–
–
55
–
55
56
–
67
71
–
–