Analog Line-In Recording - Canon HV10 Instruction Manual

6
This camcorder: Stop playback.
NOTES
We recommend powering the camcorder
using the compact power adapter.
When recording to a VCR using an analog
connection –connection type
quality of the edited tape will be lower than the
original.
When recording to a digital video recorder
using the HDV/DV terminal –connection type
( 57)–:
- If the picture does not appear, disconnect the
DV cable and restore the connection after a
short while or turn the camcorder off and then
on again.
- Proper operation cannot be guaranteed for all
digital devices equipped with a DV terminal. If
the operation does not work, use the AV IN/
OUT terminal.

Analog Line-In Recording

You can input video from an analog video
source (VCR, TV, etc.) and record the
input video on the tape in the camcorder
in DV standard. Analog video cannot be
converted to HDV standard.
Connecting
Connect the camcorder to the video input
source using an analog connection –
connection type (
3
previous section Connection Diagrams.
Recording
( 57)–, the
3
2
( 10)
57)– shown in the
Connecting to a TV or VCR
1
Load a blank tape in this camcorder.
2
Connected device: Load the
recorded cassette or disc.
3
REC PAUSE
Press
4
Connected device: Start the
playback.
In record pause mode and while
recording you can check the picture on
the camcorder's screen.
5
When the scene you wish to record
appears, press
Recording starts.
6
While recording, press
pause the recording.
In record pause, press
resume recording.
7
Press to stop recording.
8
Connected device: Stop the
playback.
IMPORTANT
Depending on the analog signal sent from the
connected device the input image may be
distorted or not be displayed at all (for example,
video input that includes copyright protection
signals or anomalous signals such as ghost
signals).
NOTES
We recommend powering the camcorder using
the compact power adapter.
61
.
/
.
/
to
/
again to
E