Table of Contents
Advertisement
GRATES:
SHIPPING RETAINER should be removed to
allow grates to turn and shake freely.
To remove a grate:
1.
Remove front casting
2.
Slide grate as far forward as possible
3.
Lift rear end of grate approximately 6 inches
4.
Slide grate back toward rear of firebox and
up
To install a grate:
1.
With rear end of grate higher than front end
slide grate forward so shaft is through grate
retaining hole at front of firebox.
2.
Lower rear end of grate and slide rear shaft
of grate into rear retaining hole.
3.
Replace front casting if coal is to be burned.
FRONT CASTING:
Use for coal burning only.
Installation in CL86-96G
1.
Remove top brick lock
2.
Put casting through firedoor and hold tight to
inside front of firebox above the brick.
Square pattern on casting should be facing
into the firebox.
3.
Lower casting so it rests on round shaft of
grates.
FRONT CASTING:
Use for coal burning only.
Installation in CL115-170G
1.
Put casting through firedoor and hold tight to
inside front of firebox above top of liners.
Square pattern on casting should be facing
into the firebox.
2.
Lower casting so it rests on round shaft of
grate.
CAST LINERS:
In CL115-170G
Hook liner pieces in retainers as shown. Install
on sequence shown by numbers 1 to 6. The
other 3 pieces are installed on opposite side from
4, 5, 6 beginning at back corner.
NOTE: This front casting is not required when
burning wood. However, this casting or provided
grate plate should be placed on top of the grates
for more efficient wood burning and to prevent
wood coals from falling through and warping
grates.
FIG. 9A - CL86G-96G FIREBOX
FIG. 9B - CL115G-170G FIREBOX
FIG. - 9C – GRATE PLATE
9
Hide quick links:
Advertisement
Table of Contents
