For Best Performance - Panasonic VL-SW251BX Operating Instructions Manual

For best performance

Before using
L I t is prohibited to disassemble or modify this unit. Contact the dealer where you purchased this unit for repair.
L W hen power fails, this unit cannot be used.
L F or the recorded image:
The recorded image may be lost when:
– Mishandled
– Electric shock or radio wave interference occurs.
– The power is turned off during use.
L P anasonic may not be liable for damages due to external factors such as power failures.
Location/avoiding noise
The main monitor station and the sub monitor station use radio waves to communicate with each other.
L F or maximum coverage and noise-free communications, install your main monitor station:
– at a convenient, high, and central location with no obstructions between the sub monitor station and main
monitor station in an indoor environment.
– away from electronic appliances such as TVs, radios, personal computers, microwave ovens, wireless
devices, wireless routers, or digital cordless phones.
– facing away from radio frequency transmitters, such as external antennas of mobile phone cell stations.
(Avoid installing the main monitor station near a window.)
L I f you use the sub monitor station near a microwave oven which is being used, noise may be heard. Move
away from the microwave oven and closer to the main monitor station.
L C overage and voice quality depends on the local environmental conditions.
Environment
L K eep the unit away from electrical noise generating devices, such as fluorescent lamps and motors.
L T he unit should be kept away from excessive smoke, dust, high temperature and vibration.
L T he unit should not be exposed to direct sunlight.
L W hen you leave the unit unused for a long period of time, unplug it from the power outlet.
L T he unit should be kept away from heat sources such as heaters, kitchen stoves, etc. It should not be placed
in rooms where the temperature is less than 0 °C or greater than 40 °C. Damp basements should also be
avoided.
L T he maximum calling distance between the main monitor station and the sub monitor station (approx. 100 m)
may be shortened when the product is used in the places:
– Where there are following obstacles between the main monitor station and the sub monitor station:
• Metal doors or metal shutters.
• Heat insulation including aluminum foil.
• Concrete walls or walls made of galvanized iron sheet.
• When using the sub monitor station on the different floor or house in the same grounds from where the
main monitor station has been installed.
• Many walls.
L O perating near 2.4 GHz electrical appliances may cause interference. Move away from the electrical
appliances.
Important:
L W hen you move the sub monitor station from a cold place to a warm place, wait a little while to let the sub
monitor station adapt to the change in environment before use. In this case, condensation such as the
formation of dew may occur, resulting in error or malfunction.
(Main monitor station/sub monitor station)
Important Information
7