General Information; Safety Instructions For Installation And Operating Personnel - Eaton CROUSE-HINDS Series Instruction Manual

GENERAL INFORMATION

This manual applies to Diagnostic Module F809F version MT02 which, for current models,
is indicated on the side label.
It can also apply to earlier model that have had a firmware update. Check in the Resource
transducer block (see section 4.1) to ensure that the following values apply:
Parameter 42 - Identification_Measurement - software version 1.1x
Parameter 43 - Identification_Fieldbus - software version 1.3x
For all models with software releases earlier than these, refer to manual INM F809F-1
which is available for download from http://www.mtl-inst.com/mtlsupport.nsf

Safety instructions for installation and operating personnel

These operating instructions contain basic safety instructions for installation, operation and maintenance and servicing. Failure
to comply with these instructions can endanger personnel, the plant and the environment.
Before installation/commissioning:
 Read the operating instructions.
 Give adequate training to the installation and operating personnel.
 Ensure that the contents of the operating instructions are fully understood by responsible personnel.
 The national installation and mounting regulations (e.g. EN 60079-14) apply.
When operating the devices:
 Make the operating instructions available at the installation area (at all times).
 Observe safety instructions.
 Observe national safety and accident prevention regulations.
 Operate the equipment within its published specification.
 Servicing/maintenance work or repairs which are not described in the operating instructions must not be performed without
prior agreement with the manufacturer.
 Any damage may render hazardous-area protection null and void.
 No changes to the devices or components impairing their hazardous-area protection are permitted.
 The device may only be fitted and used if it is in an undamaged, dry and clean state.
If there are any points that remain unclear:
 Contact your local Eaton Office
 Product and contact details are also available from the company website: http://www.mtl-inst.com
INM F809F-2C rev 2 iv iv