Summary of Contents for ICP DAS USA WISE-52 Series
Page 1
Quick Start for WISE-52xx Series October 2016, Version 1.0.3 Thank you for purchasing WISE-52xx – the Web-based Intelligent IOT controller for This Quick Start will provide you with remote monitoring and control application. minimum information to get started with WISE-52xx. It is intended for use only as a quick reference.
Page 2
-------------------------------------------------------------------------------- Configuring the boot mode Before starting WISE-52xx at the first time, be sure that the switch is placed in the “0” position. -------------------------------------------------------------------------------- Connect to PC, Network and Power The WISE-52xx is equipped with an RJ-45 Ethernet port for connection to an Ethernet hub/switch and PC.
Page 3
-------------------------------------------------------------------------------- Using Browser to Assign a New IP The WISE-52xx is an Ethernet controller, which comes with a default IP setting; therefore, you must first assign a new IP setting to the LAN1 port of WISE-52xx. The factory default IP settings of WISE-52xx are as follows: Item Default IP Address...
Page 4
-------------------------------------------------------------------------------- Go to WISE-52xx Web Site to edit Control Logic Please follow the steps below to implement IF-THEN-ELSE control logic on ICP DAS WISE-52xx controllers: Step 1: Open a browser, and type in the URL address of the WISE-52xx Open a browser and type in the URL address(The new IP setting) of the WISE-52xx in the address bar.