Toshiba RAV-RM561CTP-E Owner's Manual page 9

3
1
2
5
6
9
18
13
UNIT No. display
Displays the number of the indoor unit selected.
Also displays error code of indoor and outdoor
units.
14
Central control display
Displayed when the air conditioner is used under
the central control in combination with a central
control remote controller.
In case the remote controller is disabled by the
central control system, flashes.
The button operation is not accepted.
Even when ON / OFF, MODE, or TEMP. button is
pushed, and the button operation is not accepted.
(Settings made by the remote controller vary with
the central control mode. For details, refer to the
Owner's Manual of the central control remote
controller.)
15
Remote controller sensor display
Displayed while the sensor of the remote controller
is used.
16
Pre-heat display
Displayed when the heating mode is energized or
defrost cycle is initiated.
While this icon is displayed, the indoor fan stops.
15-EN
13
14
7 8
4 12
11
15
10
17
17
No function display
Displayed when the function requested is not
available on that model.
18
Service display
19
Operation ready display
This display appears on some models.
Operation section
Push each button to select a desired operation.
The control saves commands in memory and after the initial setting, there is no need for any additional
•
settings unless changes are desired. The air conditioner can be operated by pushing the
19
16
1
button (Temperature set button)
Adjusts the set point.
Select the desired set point by pushing
or
2
button (Timer set button)
Use to setup the timer.
3
button (Filter reset button)
Resets "
4
button (Test button)
Use only for service.
(During normal operation, do not use this button.)
5
When the button is pushed, the operation starts, and
it stops by pushing the button again.
When the operation has stopped, the operation
lamp and all the displays disappear.
6
Operation lamp
Green light illuminates when unit is on.
Although it flashes when the protection device is
operated or an error occurs.
7
button (Operation mode button)
Selects desired operation mode.
8
button (Fan speed button)
Selects the desired Fan speed.
– 8 –
1
2
3
4
9
TEMP.
TEMP. .
10
" display after cleaning filter.
11
button
12
◆ OPTION:
Remote controller sensor
Usually the temperature sensor of the indoor unit
senses the temperature. The temperature on the
surrounding of the remote controller can also be
sensed.
For details, contact the dealer from which you have
purchased the air conditioner.
button.
5
6
7
8
9
10
11
12
button (Ventilation button)
Use when a power ventilation kit (locally procured)
is connected.
• If " " is displayed on the remote controller
when this button is pushed, no vent kit
connected.
button (Power save operation)
Use to initiate power saving mode.
button (Unit / Louver select button)
Selects a unit number (left) and louver number
(right).
UNIT:
Selects an indoor unit when adjusting wind
direction multiple indoor units are controlled with
one remote controller.
LOUVER:
Selects a louver when wind direction adjustment is
set independently.
button (Swing / Louver direction
button)
Selects automatic swing or setting the louver
direction.
EN
ID
ID
16-EN